Skate

Materials needed|
| ?   1 - 4×8, 3/4 plywood
?   4 - 2×4s, 8 long
?   3 - 2×6s, 8 long
?   1 - box of 1 5/8 screws
?   1 - box of 2 1/2 screws
?   2 - 2×2, 1/4 tip off iron|
|
|
Tools needed|
| ?   Tape Measure & Pencil
?   placard saw
?   Drill w/ philips berth
?   1/16 drill bit|
|
Gather your real(a)s. Start with the 2×4s. Cut all 4 of them down to 3-9 in aloofness. (you will get two proscribed of each 8 long 2×4). Set them aside. Now restitution the 2×6s and cut one of them into two pieces 3-9 in length and leave the other two at 8-0 for the sides. Below is the material cut list.

Material Cut List|
Lumber|
Qty.|  |  |  | image|  | Size| | |
6|  | |  | 2×4|  | 3-9| | |
2|  | |  | 2×6|  | 3-9| | |
2|  | |  | 2×6|  | 8-0| | |
| Plywood|
Qty.|  |  |  | event|  | Size| | |
1|  | |  | 3/4 Ply|  | 4-0 × 8-0| | |
 |  |  |  |  |  |  | | |
 |  |  |  |  |  |  | | |
| brace|
Qty.



|  |  |  | Type|  | Size| | |
2|  | |  | 2×2×1/4 Angle|  | 8-0| | |
 |  |  |  |  |  |  | | |
 |  |  |  |  |  |  | | |
|

Framing the outside

Take the two 2×6s that you cut down to 3-9 and attach them to the two 8-0 long 2×6s as shown.
You should pre-drill the screw locations near the ends with a 1/16 drill bit to keep them from splitting.

Framing the inside

Now sic the 2×4s inside the structure you just assembled at 10 1/2 on center. Flip the whole matter on its back and lay it on a compressed surface to pull back it easier to attach these 2×4s.

Placing the plywood

Flip it oer so that the 2×4s are at the top once more and place your sheet of 3/4 plywood on top. Attach it to the framed portion with 1 5/8 screws.

Attaching the coping

If you want to add some angle iron to the edges and make it a manual pad / small grind ledge, do so by following the instructions on the ledge plans....If you want to get a full essay, order it on our website: Orderessay



If you want to get a full essay, wisit our page: write my essay .